Sending 5, 100-byte ICMP Echos to 8.8.8.8, timeout is 2 seconds: Sending 5, 100-byte ICMP Echos to 192.168.1.1, timeout is 2 seconds: INFO: Security level for 'outside' set to 0 by default.ĪSA5505(config)# route outside 0 0 192.168.1.1 // STATIC DEFAULT ROUTE TO 871WĪSA5505(config)# interface ethernet0/0 // E0/0 PORT IS USED FOR WAN BY DEFAULT INFO: A hostname must start and end with a letter or digit, and have as interior characters only letters, digits, or a hyphen.ĪSA5505(config)# username cisco password cisco privilege 15 // NOT RECOMMENDED IN A PRODUCTION NETWORKĪSA5505(config-if)# ip address 172.16.1.1 255.255.255.0 Another good reason for doing this setup is that NAT is much simpler to configure and mange on a Cisco router. This scenario fits with my current network topology since I wanted my 871w router to function as the Internet edge router and the ASA 5505 behind it. Nameif and without a 'no forward' command on this interface or on 1 interface(s) Intercompany Media Engine : Disabled perpetualĮRROR: This license does not allow configuring more than 2 interfaces with

Maximum Physical Interfaces : 8 perpetualĪn圜onnect Essentials : Disabled perpetualĪn圜onnect for Mobile : Disabled perpetualĪn圜onnect for Cisco VPN Phone : Disabled perpetualĪdvanced Endpoint Assessment : Disabled perpetualīotnet Traffic Filter : Disabled perpetual

I could setup the firewall with a DMZ, but it would only be 'restricted.' This means that if I add a DMZ network, it can only go out to the outside (Internet) while the inside network can communicate with both the outside and DMZ network. I did a two network approach using the 'inside' and 'outside' network since my ASA 5505 has a Base License, which supports only 3 VLANs. So I took out my ASA 5505 to test my firewall skills, made a factory default and hooked it up on my lab network. I'm done with FIREWALL and will start my VPN very soon.

Cisco asa 5505 end of life